|
SUPERWINCH |
Tow Ball Winch Mount Assembly |
||
|
CONVERTS YOUR TOWING VEHICLE INTO A WINCH POWER PACK FOR PULLING & RECOVERING PORTABLE WINCH MOUNT TO KEEP YOU ON THE MOVE MANOEUVRE YOUR CARAVAN BOAT OR TRAILER WHEREVER YOU NEED WINCHING ASSISTANCE
|
|||
|
Superwinch Tow Ball Adaptability For:
Trailers, Caravans, Boats etc.
|
Standard Tow Ball (not supplied)
Superwinch Clam
Superwinch Winch Mount Plate |
||
| Fit
‘Clam’ onto standard tow ball which provides a secure square mount
for winch mounting plate
|
|||
 |
 |
||
| SPECIFICATION | |||
| Maximum Rating | 1,360 KG | ||
| Fits | Standard 50mm Tow Ball | ||
| Accepts Superwinch Winch Models | LT2000, GP Series, ATV Series, UT3000, S3000. | ||
| ATV Series, there is no provision for switch mounting | |||
|
|
|||
|
|
|||
|
SUPERWINCH |
General Wiring Kit |
||
|
You will need a good quality heavy duty battery as all winches draw a lot of current, as you can see from the specification sheet, so after use you will have to recharge the battery. When choosing a battery explain to your supplier exactly what you need the battery for, and give the current draw figures. If you want to connect the winch directly to the car battery or a caravan battery you must use good quality cable, the same type as your car battery uses. Some winches come with a short length of electrical connecting cable approx. 1 Mtr. to enable you to connect to a battery in close proximity, a good solid connection is required by bolting the electrical cable terminal to the battery post or via our quick fit connectors (see below), never use crocodile type clips as they do not give an adequate connection due to poor contact surface area resulting in high resistance at the point of contact, this will cause a voltage drop which could result in a motor burn out. Quick Fit special plug & sockets are available for permanent vehicle wiring installations or extensions, enabling a easy and quick way to connect and disconnect your winch from the battery. You could have one of these special female sockets fitted to the rear of your car, or the "A" Frame if you are going to use the caravan boat or trailer battery, and the special male plug fitted to your winch. You can NOT use your 7 pin trailer socket due to the very high current draw, see technical specifications. To comply with EC Directive regulations and as a matter of safety an Isolator switch must also be fitted.
|
|||
| Wiring Kit Complete |  |
||
|
|
|||
| Quick Fit Connectors Only |
|
||
|
|
|||
| Safety Isolator Switch |
Isolator Switch MUST be fitted to all winches.
|
||
